|
|
|
NEW! MP3 player with motion
sensor input and delay timer |
|
| Looking at add CD-quality sound
to your kiosk or prop? Can't find a way to trigger your MP3 player?
Look no further - the AP2 MP3 player provides CD-quality audio output
and the ability to trigger an audio track using a standard sensor
such as a passive infra-red (PIR) sensor. The AP2 plays any MP3 audio
track from a microSD card (not included) inserted in the on-board
microSD card socket. The board supports two play modes - random and
sequential. In 'random' mode, a random audio track will be selected
each time a trigger input is received. In 'sequential' mode, up to
99 audio tracks with numbered filenames will be used and each trigger
input will play the next sequential file. In either mode once an audio
track begins to play it will not accept another trigger until the
track has completed. The trigger signal can be any DC voltage from
3.3V up to 12V. In addition, a selectable delay timer allows you to
adjust the amount of time after an audio track finishes before
another trigger will be accepted. There is also a 'trigger out' signal
which provides a 5V signal that can be used to control other props
which will go high for as long as the audio track plays. |
| |
|
|
Board Dimensions: 2.5" x 2.5" (64mm x 64mm)
Requires 5VDC power supply (not included)
Plays high quality MP3 audio tracks stored on microSD card (not included)
Always plays complete audio track before accepting another trigger
Audio output is standard 1/8" headphone jack
Terminal block connectors for 5V out, ground, trigger input (3.3V
- 12V input level) and trigger output (5V level)
Trigger-out signal (5V level) can be used to control other props
Adjustable delay timer to prevent continuous triggers
LEDs to indicate trigger in, trigger out and delay period
|
| |
|
|
|
|
