|
|
|
NEW! PC1 Prop Controller
board with trigger input and delay timer |
|
| Looking for a way to record a sequence of lights, motors
or other devices and then play back this sequence when someone walks by? The PC1 Prop Controller provides
the ability to record up to 13 minutes of actions on 2 independant relays and then play the sequence
back when a trigger signal is detected from a sensor such as a PIR motion sensor. The controller will
always play the entire sequence even if a trigger occurs while the sequence is playing. In addition, you can adjust the length
of time after the sequence has played before another trigger
is recognized to prevent constant triggers. There are inputs for both high-active (3.3V - 12V) and low-active triggers so almost any
trigger device can be made to work with this controller. The relays provide both Normally Open and
Normally Closed connections. The relays are rated at
10A 250V (AC) and 5A 100V (DC). |
| |
|
|
Board Dimensions: 3.75" x 2.5" (96mm x 64mm)
Requires 12VDC power supply (not included)
Records up to 13 minutes of actions for the relays and them plays the sequence back when triggered
Terminal block connectors for 5V out, Gnd, high active trigger input (3.3V - 12V input level),
low active trigger input (0V) and trigger output
Trigger-out signal (5V level) can be used to control other props
Adjustable Off-time from 15sec to 30 min to prevent continuous triggers
LEDs to indicate trigger in, trigger out and delay
|
| |
|
|
|
|
