|
|
|
RB4 Relay Controller Board |
|
| Looking for an easy way to turn on lights, motors
or other devices with an Arduino or other microcontroller board? Are you wanting to use your servo controller board (such as Lynxmotion SSC-32) to control lights or motors? The RB4 Relay Controller provides
the ability to control 4 relays independantly using only a standard 5V logic signal. Better yet, each relay
has the same connector that a standard servo motor has so all you have to do is connect each relay connector
to the servo controller the same way you would connect a standard servo motor.
Each relay has its own input - when the input signal is at 5V (logic high) the relay is turned on and when the signal input is at 0V (logic low) then relay will be off. Any
device that produces a 5V signal can be used to control these relays - Arduino or other microcontroller board, prop controller, servo controller even a simple battery and switch could be used.
Each of the 4 relays provide both Normally Open and Normally Closed connections will remain in the off position if not connected. The relays are rated at
8A 240V (AC) and 5A 100V (DC). |
| |
|
|
Board Dimensions: 3.875" x 2.375" (98mm x 60mm)
Requires 12VDC power supply (not included)
East to use with any Arduino or other microcontroller board like Basic Stamp or PicAxe.
Each relay has 12" lead wire and standard 3-pin connector for connection to a servo controller
Massive terminal block connectors for large gauge wires
LEDs to indicate when each relay is activated
|
| |
|
|
|
|
