|
|
|
Relay controller with motion sensor input and delay timer |
|
| Looking for a way to turn on lights, motors
or other devices when someone walks by? The RT1 Relay Controller provides
the ability to turn on 2 relays when a trigger is detected from a sensor such as a PIR motion sensor. The length
of time the relays are on AND the delay time before another trigger
is recognized are both selectable on the board. The trigger input
can be any device that can provide a 5V signal such as our passive
infra-red (PIR) sensor. The relays provide both Normally Open and
Normally Closed connections and operate together so you can have 2
devices turn on and off at the same time. The relays are rated at
10A 250V (AC) and 5A 100V (DC). |
| |
|
|
Board Dimensions: 3.75" x 2.5" (96mm x 64mm)
Requires 9-12VDC power supply (not included)
Terminal block connectors for 5V out, Gnd and trigger input (5V input level) and trigger output
Trigger-out signal (5V level) can be used to control other props
Adjustable On-time from 5sec to 5 min
Adjustable Off-time from 15sec to 30 min to prevent continuous triggers
LEDs to indicate trigger in, trigger out and delay
|
| |
|
|
|
|
