|
|
|
| Not satisfied with LED eyes of a single
color? No problem - our tri-color RGB (red-green-blue) LED controller
uses two high-intensity Pirahna RGB LEDs which have red, green and
blue LEDs encased in a single package. This controller has three
channels that connect to your servo controller - one each for the
red, green and blue colors. Each of these channels operates exactly
the same way as our single color models do - connect each channel
directly to your servo controller such as the Lynxmotion SSC-32 and
instead of the controller turning a servo motor it controls the brightness
of one color of the LEDs. Each color channel operates independantly
of the others so you can mix colors for infinite possibilities. No
power supply needed - it is powered directly from your servo controller!
Each color channel has the exact same connector as a servo motor -
just plug it in to your servo controller and you are ready to go.
|
| |
|
|
Board Dimensions: 1.6" x 1.1" (40mm x 26mm)
Each color channel (red, green,blue) has 12" cable with standard servo motor connector
Each of the 2 RGB LEDs are attached with 12" ribbon cable
No separate power supply needed - powered directly from servo controller
Valid voltage range is 4.7V to 9V
|
| |
|
|
|
|
